EU Authorized Representative for Contact Lens Manufacturers: Rule 5, Wear Schedule and the Mandate
Contact lenses are invasive devices with respect to a body orifice, because Annex VIII of Regulation (EU) 2017/745 treats the external surface of the eyeball as a body orifice. Rule 5 places a daily-wear corrective lens in class IIa and a lens intended for continuous wear of more than 30 days in class IIb, so a notified body is involved either way. A lens manufacturer established outside the Union must designate a sole authorized representative under Article 11 before the lenses are placed on the EU market, and the same mandate covers Türkiye.
The surface of the eye is a body orifice under Annex VIII
A contact lens is invasive, but not surgically invasive. Chapter I of Annex VIII settles that with its definition of a body orifice:
"‘Body orifice’ means any natural opening in the body, as well as the external surface of the eyeball, or any permanent artificial opening, such as a stoma." (MDR Annex VIII, Section 2.1)
The lens sits on the eyeball without a surgical operation and a corrective lens is not connected to an active device, so Rule 5 applies:
"All invasive devices with respect to body orifices, other than surgically invasive devices, which are not intended for connection to an active device or which are intended for connection to a class I active device are classified as:" (MDR Annex VIII, Rule 5)
- "class I if they are intended for transient use;"
- "class IIa if they are intended for short-term use, except if they are used in the oral cavity as far as the pharynx, in an ear canal up to the ear drum or in the nasal cavity, in which case they are classified as class I; and"
- "class IIb if they are intended for long-term use, except if they are used in the oral cavity as far as the pharynx, in an ear canal up to the ear drum or in the nasal cavity and are not liable to be absorbed by the mucous membrane, in which case they are classified as class IIa."
The exceptions in the second and third indents concern the oral cavity, ear canal and nasal cavity, not the eye. A contact lens therefore takes the main class of the indent that matches its duration of use.
Duration is counted per period of wear, not per lens life
"‘Short term’ means normally intended for continuous use for between 60 minutes and 30 days." (MDR Annex VIII, Section 1.2)
"‘Long term’ means normally intended for continuous use for more than 30 days." (MDR Annex VIII, Section 1.3)
MDCG 2021-24 explains how the overnight break is treated:
"As another example, the overnight period when contact lenses are cleaned and disinfected is considered as a discontinuation of the device use. For the determination of the duration of use, only the specified time period of uninterrupted wear of the lens (e.g. 16 hours) needs to be taken into account" (MDCG 2021-24, Section 3.1, duration of use)
Two branches follow. A daily-wear lens removed every night, whether replaced daily, every two weeks or monthly, is intended for continuous use of between 60 minutes and 30 days per wear period: short term, class IIa. MDCG 2021-24 lists short term corrective contact lenses as a class IIa example. A lens the manufacturer intends to be worn without removal for more than 30 days is long term, class IIb, and MDCG 2021-24 lists long term corrective contact lenses there. The wear schedule stated in the instructions for use decides: extended wear up to 30 nights stays short term, a claim of continuous wear beyond 30 days moves the product to class IIb. Where the labelling allows both schedules, Section 3.5 applies:
"If several rules, or if, within the same rule, several sub-rules, apply to the same device based on the device's intended purpose, the strictest rule and sub-rule resulting in the higher classification shall apply." (MDR Annex VIII, Section 3.5)
Lens care solutions and cleaning devices are class IIb
"All devices intended specifically to be used for disinfecting, cleaning, rinsing or, where appropriate, hydrating contact lenses are classified as class IIb." (MDR Annex VIII, Rule 16)
MDCG 2021-24 lists contact lens storing solutions, cleaners for contact lenses, and ultraviolet, vibration or ultrasonic devices for cleaning and disinfecting contact lenses as class IIb examples. A manufacturer that supplies lenses and a care solution holds two classifications, and the solution carries the higher one.
Cosmetic lenses without a medical purpose fall under Annex XVI
Article 1(2) extends the Regulation to the groups of products without an intended medical purpose listed in Annex XVI, as from the date of application of the common specifications adopted under Article 9. The first group is:
"Contact lenses or other items intended to be introduced into or onto the eye." (MDR Annex XVI, point 1)
A manufacturer of plano coloured lenses established outside the Union therefore needs an authorized representative too, and the common specifications adopted under Article 9 apply. Our note on Annex XVI products covers that route.
Classification table for a contact lens range
| Product variant | Class | Rule | Notified body |
|---|---|---|---|
| Corrective lens, daily wear, removed each night | IIa | Rule 5, second indent | Yes |
| Corrective lens for continuous wear of more than 30 days | IIb | Rule 5, third indent | Yes |
| Diagnostic trial lens worn for less than 60 minutes | I | Rule 5, first indent | Limited to sterility if supplied sterile |
| Multi-purpose, storing or cleaning solution; lens cleaning device | IIb | Rule 16 | Yes |
| Plano cosmetic lens with no medical purpose | Annex XVI product, Rule 5 applied by analogy to the wear schedule | Article 1(2), Annex XVI point 1 | Yes for IIa and above |
Conformity assessment route by class
"Manufacturers of class IIa devices, other than custom-made or investigational devices, shall be subject to a conformity assessment as specified in Chapters I and III of Annex IX, and including an assessment of the technical documentation as specified in Section 4 of that Annex of at least one representative device for each category of devices." (MDR Article 52(6))
A class IIb lens or care solution follows Article 52(4), where the sampling unit is the generic device group. In both routes the notified body audits the quality management system and samples technical documentation. Lenses are supplied sterile, so sterilisation validation and the clinical evaluation for each wear schedule sit inside that documentation.
What the authorized representative mandate covers for contact lenses
The appointment turns on where the manufacturer is established, not on the class of the device:
"Where the manufacturer of a device is not established in a Member State, the device may only be placed on the Union market if the manufacturer designates a sole authorised representative." (MDR Article 11(1))
Article 11(3) fixes the minimum tasks:
"The mandate shall require, and the manufacturer shall enable, the authorised representative to perform at least the following tasks in relation to the devices that it covers:" (MDR Article 11(3))
- "verify that the EU declaration of conformity and technical documentation have been drawn up and, where applicable, that an appropriate conformity assessment procedure has been carried out by the manufacturer;"
- "immediately inform the manufacturer about complaints and reports from healthcare professionals, patients and users about suspected incidents related to a device for which they have been designated;"
For a lens manufacturer this means that the declaration of conformity, the certificate and the technical documentation for every wear schedule are checked before the mandate record is created in EUDAMED, and that complaints from opticians and wearers reach the manufacturer without delay. The mandate agreement sets out how each task is performed.
One mandate for the European Union and Türkiye
Medex Kurumsal Danışmanlık acts as EU authorized representative under EUDAMED SRN TR-AR-000057550, with offices in Ankara and İstanbul. A manufacturer of contact lenses established outside the EU and Türkiye does not need two representatives:
"manufacturers established outside the territory of the EU or Turkey only need to designate one authorised representative, either in the EU or in Turkey, in order to place medical devices on the market in the EU or in Turkey." (European Commission, Notice to Stakeholders, EU-Turkey Customs Union Agreement in the field of medical devices, March 2022, section I.2)
"The ’Union market’ refers to the territories of the European Union Member States, and due to the European Economic Area (EEA) is extended to Norway, Lichtenstein and Iceland, and via the Customs Union Agreement to Turkey." (MDCG 2022-16, footnote 1)
Our mandate covers the EU Member States and Türkiye; we are not a Swiss representative or UK Responsible Person, not a notified body, and we do not find importers or distributors. The published bands on our pricing page are €1,000 to 1,300 per year for class IIa, €1,200 to 1,600 per year for class IIb, with a €0 setup fee and rates fixed for three years from signature. Registration of the same contact lenses in ÜTS (Ürün Takip Sistemi), Türkiye's product tracking system, is a separate service: ÜTS registration of contact lenses in Türkiye (Turkish).
The symbol that identifies the representative on your label is explained in our guide to the EC REP meaning. If some devices are still placed on the market under the former directives, see the authorized representative for legacy devices.
Related device categories and country pages
Other ophthalmic groups have their own pages: intraocular lenses and spectacle frames and ophthalmic optics; sterile consumables are covered under wound dressings. All groups are listed on the medical device categories page, and the manufacturer country pages start from the EU authorized representative by country list.
Frequently asked questions
Why is a monthly replacement lens class IIa and not class IIb?
Duration of use is counted per period of uninterrupted wear. MDCG 2021-24 treats the overnight cleaning period as a discontinuation of use, so a lens removed every night is a short-term device under Rule 5 and class IIa.
Which class is an extended-wear lens cleared for 30 nights?
Short term means continuous use of between 60 minutes and 30 days, so a lens intended for up to 30 days of continuous wear stays in class IIa. A claim of continuous wear for more than 30 days is long term and class IIb.
Is our multi-purpose solution classified with the lens?
No. Companion products are classified in their own right, and Rule 16 places every product intended specifically for disinfecting, cleaning, rinsing or hydrating contact lenses in class IIb.
Do cosmetic coloured lenses need an EU authorized representative?
Yes. Contact lenses without an intended medical purpose are the first group in Annex XVI, and Article 1(2) brings them under the MDR once the common specifications apply. Article 11(1) then applies to a manufacturer established outside the Union.
Does one mandate cover the European Union and Türkiye?
Yes. The European Commission's Notice of March 2022 states that a manufacturer established outside the EU and Türkiye only needs to designate one authorized representative, either in the EU or in Türkiye. Medex is established in Türkiye under EUDAMED SRN TR-AR-000057550.
Sources and further reading
Regulation (EU) 2017/745 on medical devices (MDR), Articles 2, 10, 11, 18, 32, 52 and 54, Annex VIII - eur-lex.europa.eu
MDCG 2021-24, Guidance on classification of medical devices (October 2021) - health.ec.europa.eu
MDCG 2022-16, Guidance on authorised representatives (Regulation (EU) 2017/745 and Regulation (EU) 2017/746) - health.ec.europa.eu
European Commission, Notice to Stakeholders: EU-Turkey Customs Union Agreement in the field of medical devices (March 2022) - health.ec.europa.eu
Get a fixed-price EU REP quote for your contact lens and lens care range (reply within 1 business day).
